Stainless steel Led step light manufacturers believe that in the process of putting the construction plan into practice, it is the most basic requirement to supervise the operators to adopt the correct technological operation methods, and to construct according to the national standard atlas. For example, the atlas requires that the intermediate joint of the line must be set in the waterproof junction box. The atlas does not point out how the waterproof junction box is blocked by the Stainless steel Led step light. The waterproof junction box is actually not waterproof, because the cable bushing is connected to the waterproof junction box, unless the casing of the whole line is airtight, but it is quite difficult to do so. Therefore, it is necessary to fill the waterproof junction box with electrical sealant with stable waterproof performance.

The insulation resistance of Stainless steel Led step light should be re-measured one by one before installation and use. In addition to meeting the specification requirements (≥2 megohms), the insulation resistance should also be compared with the average measured value of this batch of products. Individuals with measurements that are much lower than the average are processed to ensure that the measurements are within the normal mass distribution range. In addition, the lamp should be sealed before installation and use. The joints around the lamp cover and the cable entry position of the lamp should be sealed with outdoor electrical sealing glue. The installation method and civil construction environment of lamps and lanterns shall meet the requirements of the product technical specification.
The above is all the content shared by Stainless steel Led step light manufacturers for you.